How to install use high-energy igniter?

High-energy igniters are also called by the manufacturing industry: higher-energy igniters, boiler igniters, boiler igniters, kiln igniters, etc.

High energy igniter

Composition of high-energy igniter: high-energy igniter box, ignition rod, special ignition cable

High energy igniter classification:

Ordinary high-energy igniter

Portable high-energy igniter

Explosion-proof high-energy igniter

Remote-controlled high-energy igniter

High energy igniter installation wiring

1. (1) The application site is a burner. A hole of Φ16.5 is opened on the burner the external thread is installed to be processed into M18×1.5. The ignition rod can be screwed in. The angry end of the ignition rod is installed on the oil pump ( Qi) 30 to 50 mm in front of the mouth.

(2) If the application site is a torch, the ignition rod must be fixed with a special ignition rod buckle, the tempering end of the ignition rod should be 100-200mm away the mouth. The ignition rod is a new-type construction ignition rod without adjusting the charging discharging interval.

2. The ignition device of this series consists of the igniter box, special ignition cable ignition rod. During installation, the ignition device box the ignition rod can be connected with a special ignition cable, the switching power supply is 380V.AC.