What are the components of the high-energy igniter?

What are the components of the high-energy igniter? Next, the editor will give you a detailed introduction, hoping to bring some reference to everyone!

Ignition device

Xuzhou high-energy igniter is composed of main power supply, ignition coil, distributor, ignition switch, spark plug, additional resistance its short-circuit device, high low voltage wire, etc.

1. Power supply: composed of battery generator. After starting, the ignition system displays the bottom pressure electromagnetic energy the battery; after starting, when the generator working voltage is higher than the car battery voltage, the ignition system displays the bottom pressure electromagnetic energy the generator.

2. Ignition coil: convert the 12V bottom piezoelectric voltage produced by the car's switching power supply into high-voltage electricity that can penetrate the spark plug's electrical level gap.

3. Distributor: Under the camshaft drive of the generator engine, connect disconnect the primary secondary current of the ignition coil on time, so that the ignition coil immediately causes high voltage, transmit the high voltage to the spark plug of each cylinder according to the ignition sequence; In addition, the ignition time can be adjusted fully automatically artificially. Among them, the power capacitor's effect is to reduce the sparks of the breaker contacts increase the working voltage of the ignition coil secondary coil.

4. Ignition power switch: Operate the ignition device to conduct the bottom pressure power circuit, control the starting stopping of the generator.

5. Spark plug: Introduce high-voltage electricity into the combustion chamber of the engine, causing spark discharge to ignite the mixed gas.

6. Additional resistance short-circuiting device: short-circuit the additional resistance when starting, increase the primary current of the ignition coil, enhance the sparking energy of the spark plug during starting.